Surface PrepWork Efflorescence, Rust, Grout Haze and Mortar Dissolver
$14.00 – $52.96
Shipping : FREE on all orders above $20 in the continental US
Buy it with...…
PrepWork Concentrated, Efflorescence Dissolver, Grout Haze and Rust Stain Remover for Concrete, Pavers, Brick and Tile
- Dissolves Rust and Oxides
- Dissolves Mortar Quickly and Efficiently
- Removes Efflorescence
- OSHA Compliant
- DOT Classification: Not Regulated
- Safe on All Surfaces
- Safe on Skin
- Up to 10 times more effective than other industry products when dissolving Calcium Carbonate
Surface cleaning and preparation of:
- Interlocking concrete pavers
- Exposed aggregate concrete
- Concrete retaining walls
- Masonry brick
- Mexican tile – Saltillo
- Quarry Tiles
- Ceramic and porcelain
- Cement Terrazzo
- Hard water stains
- Grout Haze
- Mineral deposits
- Cement smears
24 months in unopened container. Do not allow to freeze.
Each Diluted Gallon of Surface PrepWork will cover between 100 to – 200 sq. ft. depending upon the porosity of the surface.
PrepWork can be used on the job without any neutralization.
Depending on the build-up to be removed, PrepWork can be diluted with up to 10 parts of water.
Always prewet the surface to be cleaned.
Apply PrepWork thoroughly to the area to be cleaned. Let stand for approximately 5 minutes. Rinse thoroughly.
Repeat if necessary.
Recommended dilution PrepWork: Water
Pavers: 1 part: 5 parts water
Broom finished concrete: 1part: 2 parts water
Concrete Block: 1part: 4 parts water
Trowel finished concrete: 1part: 7 parts water
Scrubbing with a stiff brush may be necessary to remove heavy deposits of efflorescence or cement scale.
Allow the floor to dry before applying any subsequent floors sealer.
Frequently Asked Questions
GlazeGuard is a tough clear sealer and very hard wearing. It tends to keep its shine for a long time but it can still be scratched. Especially if you drag sharp objects, like heavy kitchen appliances or point loads like table legs or chair legs.
To spot repair or recoat entire area it is not necessary to strip the sealer, you just need to sand or scrub the surface clean so it can be top coated. Sand with 120 grit sand paper or scrub with black pad and GlossGlean neutral cleaner. Clean off the dust or residue and apply a top coat. For more detailed instructions see GlazeGuard Maintenance instructions
GlazeGuard when fully cured has a hard surface so dirt does not easily stick to it. You don’t need to use aggressive cleaners. An part of maintaining your floor is to use dust mop or “swiffer” type microfiber mop to keep sand and dirt off the floor. After that to wash the floor you can use neutral clean or mild liquid detergents, light vinegar solutions, or light ammonia solutions.
Stay away from solvents like Paint strippers, Acetone and Xylene. If you do have use concentrated cleaners/degreasers. Clean up residue right away. In general make sure all standard floor cleaners are diluted in accordance with manufactures instructions. For more information see GlazeGuard Maintenance instructions.