SurfaceClean Hard Surface Cleaner and Degreaser
$14.00 – $133.10
FREE Shipping on all orders above $20 in the continental US
SurfaceClean Hard Surface, Water-Soluble Industrial Floor Cleaner Degreaser
Features
- High strength formula
- Easy to use
- Cost effective
- Environmentally responsible
- Rinses freely and easily with water
- Low odor
- Does not harm finishes
Typical Uses
- Concrete Floors and Slabs
- All Roof type substrates
- Brick and Block Pavers
- Tile and Stone
- Woodwork
- Vinyl sidings
- Stains
- Metal substrates
Directions
Dilute 1 part SurfaceClean with 3 part water. Apply by spray or brush to area at approximately 200ft² per gallon (4.9m² per liter). Allow 10 to 15 minutes for penetration. Rinse off with clean water using a 1200psi pressure washer. For unusually deep seated grease and oil stains, a second application may be necessary.
Apply full strength cleaner to very old surfaces. To clean roofer’s tools, allow to soak in pail of 1:1 solution of SurfaceClean overnight.
Coverage
Coverage is dependent upon relative cleanliness of the substrate and the porosity. Approximately 200ft2 per diluted gallon.
Frequently Asked Questions
GlazeGuard is a tough clear sealer and very hard wearing. It tends to keep its shine for a long time but it can still be scratched. Especially if you drag sharp objects, like heavy kitchen appliances or point loads like table legs or chair legs.
To spot repair or recoat entire area it is not necessary to strip the sealer, you just need to sand or scrub the surface clean so it can be top coated. Sand with 120 grit sand paper or scrub with black pad and GlossGlean neutral cleaner. Clean off the dust or residue and apply a top coat. For more detailed instructions see GlazeGuard Maintenance instructions